A) chopsticks process:

Respect Chinese traditional manual only chopsticks craft, inheritance xiu ACTS the role of technology in one hundred, from the material, shaping, carving, xiu, chopsticks are used for traditional system process. Its fine kit kat, not ordinary modern technology can match, each pair of chopsticks after more than three months of production cycle, after more than 40 to process, in addition to painting techniques, Mosaic, and at the same time using the carved lacquer, paint and other techniques

Annatto handicraft technology:

Annatto basic mainly handmade crafts, to cycle is long, and annatto handicraft production process is very tedious, need a lot of process between the original wood to the finished product. Covers the following:

After cutting material log back to the factory, wood logs bandsaw into different plate thickness, can match the length, comprehensive utilization, reduce waste, save annatto of scarce resources.

Drying process of different thickness of sheet through classification, respectively into the drying kiln drying. General thick plate about 40 days to dry, thin plank need 15 days or so, until the moisture content in wood drying to 8% - 12%, at present a lot of annatto handicraft production manufacturers have a good drying method, the process, however, at least not less than 10 days. Because must control the timber with local humidity balance, furniture made in the future is not easy to crack and deformation.

Cutting processing flow to different parts according to the product needs to be dry good timber cut into appropriate size, after pressure planing to make more accurate size, then carries on the tenon. Now commonly used machine for tenon, because annatto structure solid foundation is built on the machining process of meticulous, therefore, mechanical precision, sharp knives, adept skills are short of one cannot.

General annatto handicraft carving process has some simple or complex of carve patterns or designs on woodwork to decorate, so before assembly, the wood will send need engraving materials to carving workshop, accumulation and carving is a very time consuming, and according to the different method of carving, the worker's proficiency and figure and simplified, the time required for are also quite different. Bed of carve patterns or designs on woodwork around, for example, if the pattern is tedious, even if is a skilled worker also need to spend more than a month of time to sculpture.

Assembly after been carved pieces of panel returned to carpentry workshop, start assembly link, slowly, a redwood crafts cheeper line came out. In the process of assembly, must want difference exists close, good grasp of mortise and tenon joint interface, or tight hard kao will to wood cracks, loose, make the product twist apart.

Blow grind at this link, the whole product cheeper line out, but the entire surface of the product looks very rough, so the shaving, grinding process. Blow grind is an important step in the process of annatto production, honed to good or bad directly affect the consumer's first impression of annatto handicraft.

Lacquer wax wax or paint or is annatto handicraft production process of the last process. Sold on the market at present the annatto handicraft are without lacquer wax or link, the product after polishing directly into the market. But most are need to be further paint or wax. Generally south of annatto handicraft painting is more, the north is habit waxing or walnut oil. Painting process need time is long, like shenzhen royal is handicraft co., LTD production of "imperial is beauty" annatto handicraft, generally for painting, working procedures such as wax is very elegant.